Residential
The decisive question is almost never which elevator you like. It is what your house will take.
A home elevator is usually bought for one of three reasons: a family member for whom stairs have become difficult, a house tall enough that daily life is affected, or a new home where the owner would rather install it now than cut a hole in a finished building later.
| Factor | What to check |
|---|---|
| Footprint | A clear, structurally sound vertical run from the lowest to the highest floor served |
| Pit | A recess below the lowest floor; depth required depends on the system |
| Headroom | Clearance above the top floor served |
| Structure | Walls or a self-supporting structure able to carry the loads |
| Power | Appropriate supply and protection; standby if continuity matters |
| Access | A route to bring equipment into the house |
| Maintenance | Safe access for the equipment's service life |
In an existing house, pit depth and headroom are usually the binding constraints, and they are the first two things a survey establishes.
Provide for the elevator at design stage. Shaft, pit and power designed in cost a fraction of what they cost later, and you keep far more choice over equipment and cabin size.
Retrofits are common and frequently successful. The usual locations are an existing stairwell void, an internal room stacked across floors, or an external shaft added to the building. Each has consequences for structure, weatherproofing and the look of the house, and the survey weighs them against each other.
Where the elevator is being installed for someone with limited mobility, the details that matter are cabin dimensions for a walker or wheelchair and whether a carer travels too, door width and door type, control height and legibility, and level landings with no threshold step.
Tell us at enquiry if accessibility is the reason for the project, because it changes the specification rather than decorating it.
A home elevator is a mechanical system used daily and needs regular servicing. AMC and preventive maintenance.
Decide early what should happen during an outage, particularly if the elevator is relied on by someone with limited mobility.
Doors, controls and interlocks matter in a home with young children; raise it at specification stage.
Machinery produces some noise and vibration. Position matters — a shaft adjoining a bedroom wall is worth thinking about before it is built.
Usually, yes. Pit depth, headroom and a structurally sound vertical run decide what is possible. A survey gives a definite answer.
More than the cabin, because the shaft, equipment and clearances all sit outside the space you travel in. The finished cabin is always smaller than the structural opening.
Not necessarily. It depends on the system specified; several residential types do not require a separate machine room.
It depends on travel height, number of stops, system type, cabin specification and how much building work the installation requires — which in a retrofit is often the largest variable. A survey produces a real figure.