AONN.

Home  /  Elevator solutions

Automotive

Hydraulic lifting for showrooms, workshops and service centres

A different engineering problem from passenger elevators — and usually bought to solve an operational one.

Too few bays, a display car that needs to go on the first floor, or a workshop whose existing lift is slowing technicians down. We treat vehicle lifting as its own specialism because the selection criteria have almost nothing in common with passenger equipment.

What matters here is the heaviest vehicle you will ever put on it, how the platform meets the work being done, and whether the floor can take the load.

Applications

ApplicationWhat it typically needs
Showroom displayMoving vehicles between display floors; appearance matters as much as function
Service bay liftingLifting for underbody work; frequent daily cycles
Vehicle transfer between floorsMoving vehicles vertically in multi-level premises
Parking and stackingIncreasing vehicle capacity in a constrained footprint
Heavy vehicle workLarger capacity equipment for commercial vehicles

How vehicle lifting equipment is selected

Get these eight right and the rest follows. Get the first one wrong and nothing else helps.

CriterionWhat to establish
Rated capacityThe heaviest vehicle the equipment will ever lift, with a margin — not the average
Vehicle dimensionsLength, width, wheelbase and ground clearance of the largest vehicle handled
Platform configurationFull platform, runway or post-type, depending on the work performed
Lifting heightWorking height for technicians, or floor-to-floor travel for transfer
Floor structureWhether the slab can take concentrated loads — frequently the deciding constraint
Pit or recessWhether the installation requires excavation
Duty cycleLifts per day, which drives equipment class and maintenance
Power supplyAvailable supply and protection at the installation point

On capacity. Specify for the heaviest vehicle, not the typical one. A workshop that handles mostly hatchbacks but occasionally takes an SUV needs equipment rated for the SUV. This is the most common and most consequential error in vehicle lift selection.

On floor structure. In retrofits, the existing slab is the constraint that most often changes the plan. A surface-mounted lift concentrates substantial load into a small area, and whether the floor takes it has to be assessed rather than assumed.

Showroom installations

A lift in a showroom is seen by customers, so the requirements extend past function: finish and appearance consistent with the showroom interior, smooth and quiet operation, platform and edge detailing that works visually at close range, and safe separation between the lift area and customer circulation.

Where a vehicle is displayed on an upper floor, the lift is frequently the only way to get it there — which makes its reliability a commercial matter, not a maintenance one.

Workshop and service centre installations

Here the equipment is production capacity. Priorities shift to bay layout and technician access around the raised vehicle, lifting height matched to the work, cycle speed at the rate the bay actually turns over, equipment durability under daily duty, and safety provisions including locks and controls.

Downtime on a service lift takes a bay out of production, which is why maintenance for this equipment is worth planning deliberately rather than reactively.

Safety and operation

Vehicle lifting equipment carries heavy loads over people working beneath them. The provisions that matter are mechanical locking independent of hydraulic pressure, controls positioned so the operator can see the vehicle, load limits that are known and observed, correct positioning for the vehicle's lifting points, and regular inspection of structure, hydraulics and locks.

Common questions

What capacity do we need?

Rate for the heaviest vehicle you will ever lift, with margin — not the one you lift most often.

Can a lift be installed in an existing workshop?

Usually, subject to the floor structure, available height and power. Floor capacity is the most common constraint, and it needs assessment rather than assumption.

Do we need a pit?

It depends on the type. In-ground installations need excavation; surface-mounted types do not, but need adequate floor strength and headroom.

Can a lift move vehicles between floors?

Yes — that is a vehicle transfer installation rather than a service lift, and it is specified differently: travel height, structure and enclosure all change.

Do you service vehicle lifts installed by someone else?

In many cases, yes, subject to technical feasibility and parts availability — the same basis as our multi-brand elevator work.

Tell us about the building.